Equivalent friction coefficient f and rope groove shape
The frictional force generated when the traction rope comes into contact with the rope groove of different shapes of the traction wheel is different, and the greater the frictional force, the greater the traction force. From the perspective of usage, there are several types: semi-circular groove, V-shaped groove, semi-circular groove with cut. The semi-circular groove f is the smallest and is used for the winding traction wheel. The V-shaped wheel f is the largest and increases with the decrease of the opening angle, but at the same time, the wear also increases, which causes wear and jamming of the traction rope. As it wears out, it tends towards a semi-circular groove. The semi-circular groove f is located between the two, and it basically does not change with wear, making it widely used. The lubrication of the steel wire rope in the rope groove also directly affects the friction coefficient. Only slight lubrication of the oil core inside the rope can be used, and lubricating oil should not be applied outside the rope to avoid reducing the friction coefficient, causing slippage, and reducing drag force.
The wrapping angle of the traction rope on the traction wheel
Baojiao refers to the curvature of the contact between the traction steel wire rope and the rope groove. The larger the angle of the package, the greater the frictional force, which means that the drag force also increases, improving the safety of the elevator. There are two main methods to increase the package angle. One is to use a 2:1 traction ratio to increase the package angle to 180 °. Another type is the rewinding type (α 1+α 2).
The winding method of elevator traction steel wire rope mainly depends on factors such as traction conditions, rated load capacity, and rated speed. It has multiple types. These winding methods can also be regarded as different transmission methods. Different winding methods have different transmission speed ratios, also called traction ratio, which is the ratio of the linear speed of the traction sheave pitch circle to the car running speed when the elevator is running. The number of times the steel wire rope is wound on the traction wheel can be divided into single winding and rewinding. In single winding, the steel wire rope is only wound once on the traction wheel, with a wrap angle of less than or equal to 180 °, while in rewinding, the steel wire rope is wound twice on the traction wheel, with a wrap angle greater than 180 °.




