Nov 14, 2025 Leave a message

Relevant Information On Traction Machine

Working Conditions
Altitude not exceeding 1000 meters.
The air temperature inside the computer room should be maintained between 5 degrees Celsius and 40 degrees Celsius.
The ambient air does not contain corrosive or flammable gases.
The fluctuation of the power supply voltage shall not exceed a deviation of plus or minus 7% from the rated value, and the fluctuation of the operating frequency shall not exceed a deviation of plus or minus 1% from the rated value.
The computer room requires well lit fire-fighting equipment.


Install
The machine support beam is made of ordinary I-beams or channel steel, and its strength must comply with the relevant regulations of elevator standards, with an installation levelness of 1/1000. Before tightening the bolts at the joint between the traction machine base and the installation plane, a feeler gauge must be used to check for any gaps. If there are gaps, they should be filled with gaskets. Any form of gap will affect the operation function of the traction machine or elevator.


Lubrication
When adding lubricating oil, the position indicated on the oil gauge should also be taken into account. Too little oil can cause difficulty in lubrication, while too much may lead to oil leakage. The first oil change when using mineral oil should be done after about 400 hours of operation of the new machine. If using synthetic oil, the oil should be changed after about 700 hours of operation. In the future, mineral oil should be replaced every 2000-3000 hours (no more than 12-18 months) based on the operating conditions of the traction machine, and every 3000-4000 hours (no more than 24-36 months).


Replace Synthetic Oil
Check is the lubricating oil added to the oil mark position.
Manually release the brake and manually turn the disc to check if the traction machine is running; flexible.
Connect the wires as required and start the machine (this work must be done 20 minutes after refueling, otherwise the bearings may be damaged). Check if the traction machine is running normally (with a focus on emergency noise and vibration).


Repair
The outer surface of the traction machine should be kept clean to prevent dust and dirt, and the working surfaces of the brake wheel and traction wheel should be regularly wiped with clean cotton thread.
Regularly check the working condition of the brake, adjust and replace it in a timely manner if necessary, and pay attention to the electromagnetic coil not exceeding 90k.
Regularly check the wear of the traction wheel.
Perform regular maintenance and upkeep according to the instructions for using and maintaining the traction machine.

Send Inquiry

Home

Phone

E-mail

Inquiry