Traction Sheave
Traction wheel is the rope wheel on the traction machine, also known as traction rope wheel or drive rope wheel. It is a device for transmitting traction power in elevators, which uses the frictional force between the traction steel wire rope and the rope groove on the traction wheel rim to transmit power, and is installed on the worm gear shaft in the reducer. If it is a gearless traction machine, it should be installed on the side of the brake, on the same axis as the motor shaft and brake shaft.
(1) Material and structural requirements for traction wheels
① Material and process requirements: Due to the fact that the traction wheel has to bear all the dynamic and static loads of the car, load capacity, counterweight and other devices, it is required that the traction wheel has high strength, good toughness, wear resistance, and impact resistance. Therefore, QT60-2 ductile iron is commonly used in the material. In order to reduce the wear of the traction steel wire rope in the traction wheel groove, in addition to selecting a suitable groove type, there should be reasonable requirements for the roughness and hardness of the working surface of the groove.
② The diameter of the traction wheel: The diameter of the traction wheel should be greater than 40 times the diameter of the steel wire rope. In practice, it is generally taken as 45-55 times, sometimes even greater than 60 times. Because in order to reduce the increase in the volume of the traction machine, the reduction ratio of the reducer increases, so its diameter size should be appropriate.
③ The construction type of traction wheel: The overall traction wheel is divided into two parts, with a drum in the middle and a wheel rim type rope groove cut on the wheel rim. The outer wheel rim is fitted with the inner drum and connected together with hinge bolts to form a traction wheel as a whole. The shaft of its traction wheel is the worm gear shaft inside the reducer.
(2) The shape of the traction wheel rope groove
The traction force of the old area moving elevator is generated by the frictional force between the traction rope and the traction wheel rope groove.




