Nov 10, 2025 Leave a message

What Is A Traction Motor

The traction motors of elevators include AC motors and DC motors. The traction motor is the power source that drives the elevator to run up and down. Elevators are typical potential energy loads. According to the working nature of elevators, elevator traction motors should have the following characteristics:
1. Capable of frequent starting and braking: Elevators often start and brake more than 100 times per hour during operation, with a maximum of 180-240 times per hour. Therefore, elevator specific motors should be able to start and brake frequently, and their working mode is intermittent periodic working system.
2. Small starting current: In the design and manufacturing of squirrel cage rotors for AC motors used in elevators, although low resistance coefficient materials are still used to make the conductors, the short-circuit ring of the rotor is made of high resistance coefficient materials, which increases the resistance of the rotor winding. In this way, on the one hand, the starting current is reduced to about 2.5-3.5 times the rated current, thereby increasing the allowed number of starts per hour; On the other hand, due to the high resistance of the short-circuit end ring of the rotor, it is conducive to direct heat dissipation, and the overall effect reduces the temperature rise of the motor. And it ensures sufficient starting torque, usually around 2.5 times the rated torque. However, compared with ordinary AC motors, its mechanical characteristics, hardness, and efficiency have decreased, and the slip rate has also increased to 0.1-0.2. The mechanical characteristics become softer, which increases the speed range and prevents the motor from burning out when working under locked rotor torque.
3. Low noise during motor operation: In order to reduce the noise during motor operation, sliding bearings are used. In addition, the effective outer diameter of the stator core should be appropriately increased, and reasonable treatment should be made in terms of the shape of the stator core laminations.

Send Inquiry

Home

Phone

E-mail

Inquiry