The traction drive relationship of the traction elevator is shown in Figure 1. The electric motor, gearbox, brake, and other components installed in the machine room form the traction machine, which is the driving force for the traction drive. The traction wire rope is connected to the car at one end and the counterweight device at the other end through the traction wheel. To ensure that the elevator car and counterweight in the shaft run along the guide rails without rubbing against each other, a guide wheel is placed on the traction machine to separate them. The gravity of the elevator car and the counterweight device causes the traction steel wire rope to be compressed in the traction wheel groove, generating friction. In this way, the rotation of the electric motor drives the traction wheel to rotate, drives the steel wire rope, and drags the car and counterweight to make relative movements. The elevator car rises and the counterweight descends; The counterweight rises and the elevator car descends. So, the car runs back and forth along the guide rails in the shaft, and the elevator performs vertical transportation tasks.
The relative motion between the elevator car and the counterweight is achieved through the frictional force between the traction rope and the traction wheel. This force is called drag force or driving force. The load, position, and direction of the elevator car are all changing during operation. In order to provide sufficient traction force for elevators in various situations, the national standard GB 7588-2003 "Safety Code for Manufacturing and Installation of Elevators" stipulates that:
The traction conditions must meet: T1/T2 ≤ ef α
In the formula: T1/T2- the ratio of the larger static tension to the smaller static tension of the traction ropes on both sides of the traction wheel when the car carrying 125% of the rated load is located at the lowest floor station and the empty car is located at the highest floor station.
C1- Coefficient related to acceleration, deceleration, and special installation conditions of elevators, generally referred to as dynamic coefficient
C2- The coefficient of influence of changes in the cross-section of the traction wheel groove caused by wear (for semi-circular or notched grooves: C2=1, for V-shaped grooves: C2=1.2).
In ef α, f is the equivalent friction coefficient of the traction rope in the traction groove, and α is the wrap angle of the traction rope on the traction guide wheel. EF α is called the traction coefficient. It limits the ratio of T1/T2, and the larger the ef α, the greater the allowable values of T1/T2 and T1-T2, indicating that the elevator traction capacity is greater. Therefore, the traction coefficient of an elevator represents its traction capacity.
Nov 03, 2025
Leave a message
Working Principle Of Traction Machine
Send Inquiry




